Component Inspection (Accessory Relay)

1. Turn ignition switch OFF.
2. Remove accessory relay.
3. Check the continuity between accessory relay terminals under the following conditions.
   CONTINUITY SPECIFICATION
   
   

   Terminals	Condition	Continuity
   3 and 5	12 V direct current supply between terminals 1 and 2	Existed
   	No current supply	Not existed

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace accessory relay

Fig 1: Identifying Accessory Relay Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.