Key Fob Id Set Up With Consult-III

NOTE:

If a key fob is lost, the ID code of the lost key fob must be erased to prevent unauthorized use. A specific ID code can be erased with CONSULT-III. However, when the ID code of a lost key fob is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new key fobs must be re-registered.

Touch "WORK SUPPORT".
The items are shown on the figure can be set up.
- "REMO CONT ID REGIST"
  Use this mode to register a key fob ID code.
  
  NOTE: Register the ID code when key fob or BCM is replaced, or when additional key fob is required.
- "REMO CONT ID ERASUR"
  Use this mode to erase a key fob ID code.
- "REMO CONT ID CONFIR"
  Use this mode to confirm if a key fob ID code is registered or not.