Precautions for Harness Repair

Solder the repaired area and wrap tape around the soldered area.
NOTE: A fray of twisted lines must be within 110 mm (4.33 in).

Fig 1: Identifying Soldered And Taped Area OK Position
Courtesy of NISSAN MOTOR CO., U.S.A.
Bypass connection is never allowed at the repaired area.
NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.

Fig 2: Identifying Bypass Connection
Courtesy of NISSAN MOTOR CO., U.S.A.
Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.