LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2007 >> QX56 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0451 To P1217 >> DTC P0500 VSS >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Start engine (VDC switch OFF).
  2. Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II

    should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.

    If NG, go to "DIAGNOSTIC PROCEDURE ".

    If OK, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Warm engine up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    ENGINE TESTING CONDITION

    ENG SPEED 1, 600 - 6, 000 rpm
    COOLAN TEMP/S More than 70°C (158°F)
    B/FUEL SCHDL 6.9 - 31.8 msec
    Selector lever Except P or N position
    PW/ST SIGNAL OFF
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: CONSULT-II Display - Data Monitor
    G04900558Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals