Check BCM Power Supply and Ground Circuit

• Check 15A fuse [No. 1, located in fuse block (J/B)]
• Check 10A fuse [No. 21, located in fuse block (J/B)]
• Check 50A fusible link (letter F  , located in the fuse and fusible link box).
  NOTE: Refer to "COMPONENT PARTS AND HARNESS CONNECTOR LOCATION ".

OK or NG 

OK: GO TO 2.

NG: If fuse is blown out, be sure to eliminate cause of malfunction before installing new fuse. Refer to "POWER SUPPLY ROUTING CIRCUIT ".

Check voltage between BCM connector and ground.

Fig 1: Checking Voltage Between BCM Connector And Ground

OK or NG 

OK: GO TO 3.

NG: Check BCM power supply circuit for open or short.

1. Turn ignition switch OFF.
2. Disconnect BCM connector.
3. Check continuity between BCM connector and ground.
   CONTINUITY SPECIFICATION
   
   

   BCM connector	Terminal	Ground	Continuity
   M2	52		Yes

OK or NG 

OK: Power supply and ground circuit are OK.

NG: Check BCM ground circuit for open or short.

Fig 2: Checking Continuity Between BCM Connector And Ground