Component Inspection

1. Turn ignition switch OFF.
2. Disconnect A/T device (detention switch) harness connector.
3. Check continuity between A/T device (detention switch) terminals as follows.
   TERMINALS CONTINUITY REFERENCE
   
   

   A/T device (detention switch)			Condition		Continuity
   Connector	Terminal
   M137	10	11	A/T selector lever	P position	Not existed
   				Other than above	Existed

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace A/T device. Refer to "2WD : REMOVAL AND INSTALLATION "(2WD models) "AWD : REMOVAL AND INSTALLATION "(AWD models)