Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect push-button ignition switch harness connector.
3. Check voltage between push-button ignition switch harness connector and ground.
   TERMINALS VOLTAGE REFERENCE
   
   

   Push-button ignition switch		Ground	Voltage [V]
   Connector	Terminal
   M50	4	Ground	Battery voltage

Is the inspection normal? 

YES: GO TO 2.

NO: GO TO  4.

Refer to , "COMPONENT INSPECTION ".

Is the inspection normal? 

YES: GO TO 3.

NO: Replace push-button ignition switch. Refer to , "REMOVAL AND INSTALLATION ".

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END.

1. Disconnect BCM harness connector M122 and IPDM E/R harness connector E5.
2. Check continuity between push-button ignition switch harness connector and ground.
   TERMINALS CONTINUITY REFERENCE
   
   

   Push-button ignition switch		Ground	Continuity
   Connector	Terminal
   M50	4	Ground	Not existed

Is the inspection normal? 

YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

NO: Repair harness or connector.