Check Tilt Switch Circuit

1. CHECK FUNCTION 

   With CONSULT-II 

   With "TILT SW-UP, TILT SW-DOWN" on the DATA MONITOR, operate the ADP steering switch to check ON/OFF operation.

   Fig 1: Identifying CONSULT II Display - DATA MONITOR

   Courtesy of NISSAN MOTOR CO., U.S.A.
   TILT SW-UP, TILT SW-DOWN (WITH CONSULT-II)
   
   

   Monitor item [OPERATION or UNIT]		Contents
   TILT SW-UP	"ON/OFF"	(ON/OFF) status judged from the tilt switch (UP) signal is displayed.
   TILT SW-DOWN	"ON/OFF"	(ON/OFF) status judged from the tilt switch (DOWN) signal is displayed.

   Without CONSULT-II 

   1. Turn ignition switch OFF.
   2. Tilt switch operate, check voltage between automatic drive positioner control unit connector and ground.
   Fig 2: Identifying Voltage Between Automatic Drive Positioner Control Unit Connector And Ground
   Courtesy of NISSAN MOTOR CO., U.S.A.
   AUTOMATIC DRIVE POSITIONER CONTROL UNIT CONNECTOR AND GROUND (WITHOUT CONSULT-II)
   
   

   Connector	Terminals (Wire color)		Tilt switch condition	Voltage (V) (Approx.)
   	(+)	(-)
   M49	1 (R)	Ground	UP	0
   			Other than above	5
   	17 (R/B)		DOWN	0
   			Other than above	5

   OK or NG 

   OK: Tilt switch circuit is OK.

   NG: GO TO 2.

2. CHECK TILT SWITCH CIRCUIT HARNESS CONTINUITY 
   1. Disconnect automatic drive positioner control unit connector and ADP steering switch connector.
   2. Check continuity between automatic drive positioner control unit connector M49 terminals 1, 17 and ADP steering switch connector M13 terminals 2, 3.

      1 (R) - 2 (R) : Continuity should exist. 

      17 (R/B) - 3 (R/B) : Continuity should exist. 

   3. Check continuity between automatic drive positioner control unit connector M49 terminals 1, 17 and ground.

      1 (R) - Ground : Continuity should not exist. 

      17 (R/B) - Ground : Continuity should not exist. 

      Fig 3: Checking Tilt Switch Circuit Harness Continuity

      Courtesy of NISSAN MOTOR CO., U.S.A.

   OK or NG 

   OK: GO TO 3.

   NG: Repair or replace harness between automatic drive positioner control unit and ADP steering switch.

3. CHECK ADP TILT STEERING SWITCH 

   ADP steering switch operate, check continuity between ADP steering switch.

   Fig 4: Identifying Continuity Between ADP Steering Switch

   Courtesy of NISSAN MOTOR CO., U.S.A.
   ADP TILT STEERING SWITCH
   
   

   Connector	Terminal		ADP steering switch condition	Continuity
   M13	2	1	UP	Yes
   			Other than above	No
   	3		DOWN	Yes
   			Other than above	No

   OK or NG 

   OK: GO TO 6.

   NG: Replace ADP steering switch.

4. CHECK ADP STEERING SWITCH GROUND CIRCUIT 

   Check continuity between ADP steering switch connector M13 terminal 1 and ground.

   1 (B) - Ground : Continuity should exist. 

   Fig 5: Checking Continuity Between ADP Steering Switch Connector M13 Terminal 1 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Check the condition of the harness and connector.

NG: Repair or replace harness between ADP steering switch and ground.