LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2007 >> FX35 RWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> Fuel Tank >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: Be sure to read "General Precautions" when working on the fuel system. Refer to "GENERAL PRECAUTIONS ".
  1. Perform steps 2 to 7 of "REMOVAL" in " FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY" on main and sub fuel level sensor units. Refer to "REMOVAL ".
  2. Remove tunnel stay. Refer to "REAR SUSPENSION ASSEMBLY ".
  3. Remove exhaust front tube, center muffler and main muffler. Refer to "EXHAUST SYSTEM ".
  4. Remove insulator.
  5. Remove propeller shaft. Refer to "REAR PROPELLER SHAFT ".
  6. Remove parking rear brake cables. Refer to "PARKING BRAKE CONTROL ".
  7. Compress coil spring and remove coil spring.
  8. Remove rear suspension assembly.
  9. Remove fuel tank protector.
  10. Disconnect fuel filler hose, vent hose and EVAP hoses at fuel tank side.
    Fig 1: Identifying Fuel Filler Hose, Vent Hose And EVAP Hoses
    G05227649
  11. Support the lower part of fuel tank with transmission jack.
    CAUTION: Support the position that fuel tank mounting bands do not engage.
    Fig 2: Supporting Fuel Tank And With Transmission Jack
    G04875538
  12. Remove fuel tank mounting bands.
  13. Supporting with hands, descend transmission jack carefully, and remove fuel tank.
    CAUTION:
    • Make sure that all connection points have been disconnected.
    • Confirm there is no interference with vehicle.
  14. Remove fuel filler tube protector and fuel filler tube, if necessary.
scientia non olet · About LEMON Manuals