LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2007 >> FX35 AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Automatic Drive Positioner >> Check Passenger Side Mirror Motor Circuit

Check Passenger Side Mirror Motor Circuit

  1. CHECK DOOR MIRROR FUNCTION 

    Check the following.

    Operation malfunction caused by a foreign object caught in door mirror face edge.

    OK or NG 

    OK:

    • GO TO 2 (With CONSULT-II).
    • GO TO  3 (Without CONSULT-II).

    NG: Repair the malfunctioning parts, and check the symptom again.

  2. CHECK MIRROR MOTOR 

    With CONSULT-II 

    Check the operation with "MIRROR MOTOR RH" in the ACTIVE TEST.

    Fig 1: Identifying CONSULT II Display - ACTIVE TEST
    G04902993Courtesy of NISSAN MOTOR CO., U.S.A.
    MIRROR MOTOR

    Test item Description
    MIRROR MOTOR RH The RH mirror motor moves the mirror UP/DOWN and LEFT/RIGHT by receiving the drive signal.

    OK or NG 

    OK: Passenger side mirror motor circuit is OK.

    NG: GO TO 3.

  3. CHECK DOOR MIRROR MOTOR (PASSENGER SIDE) HARNESS CONTINUITY 
    1. Turn ignition switch OFF.
    2. Disconnect automatic drive positioner control unit connector and door mirror (passenger side) connector.
    3. Check continuity between automatic drive positioner control unit connector M49 terminal 14, 15, 30 and door mirror (passenger side) connector D32 terminal 11, 12, 13.

      14 (L/W) - 11 (PU) : Continuity should exist. 

      15 (L/B) - 12 (OR) : Continuity should exist. 

      30 (W/R) - 13 (GY) : Continuity should exist. 

    4. Check continuity between automatic drive positioner control unit connector M49 terminal 14, 15, 30 and ground.

      14 (L/W) - Ground : Continuity should not exist. 

      15 (L/B) - Ground : Continuity should not exist. 

      30 (W/R) - Ground : Continuity should not exist. 

      Fig 2: Checking Door Mirror Motor (Passenger Side) Harness Continuity
      G05221504Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 4.

    NG: Repair or replace harness between automatic drive positioner control unit and door mirror (passenger side).

  4. CHECK MIRROR MOTOR SIGNAL 
  1. Connect automatic drive positioner control unit and door mirror (passenger side) connector.
  2. Turn ignition switch ACC.
  3. Turn changeover switch RH position.
  4. Mirror switch operate, check voltage between door mirror (passenger side) connector and ground.
    5. Fig 3: Identifying Voltage Between Door Mirror (Passenger Side) Connector And Ground
    G05221502Courtesy of NISSAN MOTOR CO., U.S.A.
MIRROR MOTOR SIGNAL

Connector Terminals (Wire color) Mirror switch condition Voltage (V) (Approx.)
(+) (-)
D32 11 (PU) Ground UP Battery voltage
Other than above 0
12 (OR) LEFT Battery voltage
Other than above 0
13 (G/Y) DOWN or RIGHT Battery voltage
Other than above 0

OK or NG 

OK: Replace door mirror motor (passenger side).

NG: Check the condition of the harness and connector.

scientia non olet · About LEMON Manuals