LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2006 >> QX56 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0455 To P1217 >> DTC P0500 VSS >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Start engine (VDC switch OFF).
  2. Read " VHCL SPEED SE" in " DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.

    If NG, go to "DIAGNOSTIC PROCEDURE ".

    If OK, go to following step.

  3. Select " DATA MONITOR" mode with CONSULT-II.
  4. Warm engine up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    SPECIFIED CONDITIONS

    ENG SPEED More than 1, 600 rpm
    COOLAN TEMP/S More than 70°C (158°F)
    B/FUEL SCHDL More than 6.9 msec
    Selector lever Except P or N position
    PW/ST SIGNAL OFF
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: CONSULT II DATA MONITOR Screen
    G04133044Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals