Inspection Procedure

With CONSULT-II 

1. Turn ignition switch "ON". (Do not start engine.)
2. Select "SELF-DIAG RESULTS" mode for "VDC" with CONSULT-II.
3. Touch "ERASE".
4. Turn ignition switch "OFF" and wait at least 10 seconds.
5. Check the self-diagnostic results.
   SELF-DIAGNOSTIC RESULTS
   
   

   Self-diagnosis results
   SHIFT POSITION ERROR

Is above displayed in the self-diagnosis display? 

1. YES : GO TO 2.
2. NO : INSPECTION END

With CONSULT-II 

1. Connect CONSULT-II. Start engine.
2. In "DATA MONITOR" select "ITEM MENU" and then check P position.
   SELECTION LEVER POSITION
   
   

   Selector lever position	Position (Data monitor)
   P position	ON
   Other than P position.	OFF

OK or NG 

1. OK : Perform VDC/TCS/ABS control unit self-diagnosis again.
2. NG : GO TO 3.

Perform Park/Neutral position switch inspection. Refer to "DTC P0705 PARK/NEUTRAL POSITION SWITCH ".

Do any self-diagnosis items appear? 

1. YES : Repair indicated items and perform VDC/TCS/ABS control unit self-diagnosis again.
2. NO : Perform VDC/TCS/ABS control unit self-diagnosis again.