Check Telescopic Sensor Circuit

CHECK STEERING WHEEL TILT MECHANISM
Check the operation malfunction caused by steering wheel tilt mechanism deformation or parts are loose.

OK or NG
- OK : GO TO 2.
- NG : Repair the malfunctioning part and check again.

CHECK FUNCTION

With CONSULT-II

Operate the telescopic switch with "TELESCO SEN" on the DATA MONITOR to check that the voltage changes.

MONITOR ITEM AND CONTENTS REFERENCE

Monitor item [OPERATION or UNIT]		Contents
TELESCO SEN	"V"	The telescoping position (voltage) judged from the telescoping sensor signal is displayed.

Fig 1: Display CONSULT II - Data Monitor Screen

G04130155

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

Turn ignition switch OFF.

Check voltage between BCM connector and ground.

CONNECTORS VOLTAGE REFERENCE

Connector	Terminals (Wire color)		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
M4	62 (P/B)	Ground	Telescopic top position	2
M4	62 (P/B)	Ground	Telescopic bottom position	4

Fig 2: Identifying Voltage Between BCM Connector And Ground

G04130156

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK : System is OK.
NG : GO TO 3.

CHECK HARNESS CONTINUITY
1. Disconnect BCM connector and telescopic sensor connector.
2. Check continuity harness between BCM connector M4 terminals 53, 54, 62 and telescopic sensor connector M59 terminals 1, 2, 3.
  53 (L/W) - 3 (L/W) : Continuity should exist.
  
  54 (B/Y) - 1 (LG/B) : Continuity should exist.
  
  62 (P/B) - 2 (P/B) : Continuity should exist.
3. Check continuity harness between BCM connector M4 terminals 53, 54, 62 and ground.
  
  Fig 3: Identifying Continuity Harness Between BCM Connector M4 Terminals 53, 54, 62 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  53 (L/W) - Ground : Continuity should not exist.
  
  54 (B/Y) - Ground : Continuity should not exist.
  
  62 (P/B) - Ground : Continuity should not exist.
OK or NG
- OK : Replace telescopic sensor.
- NG : Repair or replace harness between BCM and telescopic sensor.