Diagnostic Procedure

With CONSULT-II 

1. Drive vehicle.
2. Stop vehicle and turn ignition switch OFF.
3. Turn ignition switch ON. (Do not start engine.)
4. Select "SELF-DIAG RESULTS" mode for "A/T" with CONSULT-II.

Fig 1: Consult-II SELECT DIAG MODE Display Screen

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II 

1. Drive vehicle.
2. Stop vehicle and turn ignition switch OFF.
3. Turn ignition switch ON. (Do not start engine.)
4. Perform self-diagnosis. Refer to "TCM SELF-DIAGNOSTIC PROCEDURE (NO TOOLS) ".

OK or NG 

OK: GO TO 2.

NG: Check low coast brake solenoid valve circuit and function. Refer to "DTC P1772 LOW COAST BRAKE SOLENOID VALVE ", "DTC P1774 LOW COAST BRAKE SOLENOID VALVE FUNCTION ".

Perform "DTC Confirmation Procedure". Refer to "DTC CONFIRMATION PROCEDURE ".

OK or NG 

OK: INSPECTION END 

NG: GO TO 3.

Check TCM power supply and ground circuit. Refer to "MAIN POWER SUPPLY AND GROUND CIRCUIT ".

OK or NG 

OK: GO TO 4.

NG: Repair or replace damaged parts.

Check the following.

• The A/T assembly harness connector pin terminals for damage or loose connection with harness connector.

OK or NG 

OK: Replace the control valve with TCM. Refer to "CONTROL VALVE WITH TCM AND A/T FLUID TEMPERATURE SENSOR 2 ".

NG: Repair or replace damaged parts.