Telescopic Switch Circuit Check

CHECK FUNCTION

With CONSULT-II

With "TELESCO SW-FR, TELESCO SW-RR" on the DATA MONITOR, operate the ADP steering switch to check ON/OFF operation.

MONITOR ITEM CONTENTS

Monitor item [OPERATION or UNIT]		Contents
TELESCO SW-FR	"ON/OFF"	(ON/OFF) status judged from the telescoping switch (FR) signal is displayed.
TELESCO SW-RR	"ON/OFF"	(ON/OFF) status judged from the telescoping switch (RR) signal is displayed.

Fig 1: CONSULT II DATA MONITOR Screen

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

Turn ignition switch OFF.
Check voltage between automatic drive positioner control unit connector and ground.

AUTOMATIC DRIVE POSITIONER CONTROL UNIT CONNECTOR AND GROUND VOLTAGE

Automatic drive positioner control unit connector	Terminals		Telescopic switch condition	Voltage (V) (Approx.)
Automatic drive positioner control unit connector	(+)	(-)	Telescopic switch condition	Voltage (V) (Approx.)
M6	11	Ground	FORWARD	0
	11		Other than above	5
	27		BACKWARD	0
	27		Other than above	5

Fig 2: Identifying Voltage Between Automatic Drive Positioner Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Telescopic switch circuit is OK.

NG: GO TO 2.

CHECK TELESCOPIC CIRCUIT HARNESS CONTINUITY

Disconnect automatic drive positioner control unit connector and ADP steering switch connector.

Check continuity between automatic drive positioner control unit connector and ADP steering switch connector.

AUTOMATIC DRIVE POSITIONER CONTROL UNIT CONNECTOR AND ADP STEERING SWITCH CONNECTOR CONTINUITY

A		B		Continuity
Automatic drive positioner control unit connector	Terminal	ADP steering switch connector	Terminal	Continuity
M6	11	M46	5	Yes
M6	27	M46	4	Yes

Check continuity between automatic drive positioner control unit connector and ground.

AUTOMATIC DRIVE POSITIONER CONTROL UNIT CONNECTOR AND GROUND CONTINUITY

A		Ground	Continuity
Automatic drive positioner control unit connector	Terminal
M6	11		No
	27

Fig 3: Identifying Continuity Between Automatic Drive Positioner Control Unit Connector And ADP Steering Switch Connector

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 3.

NG: Repair or replace harness.

CHECK TELESCOPIC SWITCH

ADP steering switch operate, check continuity ADP steering switch.

ADP STEERING SWITCH CONTINUITY

ADP steering switch	Terminal		ADP steering switch condition	Continuity
M46	5	1	FORWARD	Yes
	5		Other than above	No
	4		BACKWARD	Yes
	4		Other than above	No

Fig 4: Identifying ADP Steering Switch Continuity

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 4.

NG: Replace ADP steering switch.

CHECK ADP STEERING SWITCH GROUND CIRCUIT

Check continuity between ADP steering switch connector and ground.

ADP STEERING SWITCH CONNECTOR AND GROUND CONTINUITY

ADP steering switch connector	Terminal	Ground	Continuity
M46	1	Ground	Yes

Fig 5: Identifying Continuity Between ADP Steering Switch Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace automatic drive positioner control unit.

NG: Replace or replace harness.