Diagnostic Procedure

Perform the self-diagnosis. Refer to "SELF-DIAGNOSTIC RESULT MODE ", "DIAGNOSTIC PROCEDURE WITHOUT CONSULT-II ".

Is a malfunction in the CAN communication indicated in the results?

YES : Check CAN communication line. Refer to "DTC U1000 CAN COMMUNICATION LINE ".

NO : GO TO 2.

With CONSULT-II 

1. Turn ignition switch ON. (Do not start engine.)
2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "A/T" with CONSULT-II.
3. Read out ON/OFF switching action of the "BRAKE SW".
   DATA MONITOR REFERENCE CHART
   
   

   Item name	Condition	Display value
   BRAKE SW	Depressed brake pedal.	ON
   	Released brake pedal.	OFF

OK or NG 

OK : INSPECTION END 

NG : GO TO 3.

Fig 1: CONSULT II Display - Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

Check continuity between stop lamp switch harness connector E210 terminals 1 and 2. Refer to "WIRING DIAGRAM - AT - NONDTC ".

Check stop lamp switch after adjusting brake pedal - refer to " BRAKE PEDAL  "  .

OK or NG 

OK : Check the following items. If NG, repair or replace damaged parts.

• Harness for short or open between battery and stop lamp switch.
• Harness for short or open between stop lamp switch and unified meter and A/C amp.

NG : Repair or replace the stop lamp switch.

Fig 2: Checking Continuity Between Stop Lamp Switch Harness Connector E210 Terminals 1 And 2

Courtesy of NISSAN MOTOR CO., U.S.A.