Check Tilt Sensor Circuit

With CONSULT-II 

With "TILT SEN" on the DATA MONITOR, operate the tilt switch to make sure voltage changes.

Fig 1: CONSULT-II Function Display - DATA MONITOR

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II 

1. Turn ignition switch OFF.
2. Check voltage between automatic drive positioner control unit connector and ground.
   TERMINAL VOLTAGE CHART
   
   

   Connector	Terminals (Wire color)		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   M49	7 (Y/R)	Ground	Tilt top position	2
   			Tilt bottom position	4

OK or NG 

OK : Tilt sensor circuit is OK.

NG : GO TO 2.

Fig 2: Identifying Voltage Between Automatic Drive Positioner Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Disconnect automatic drive positioner control unit connector and tilt sensor and telescopic sensor connector.
2. Check continuity harness between automatic drive positioner control unit connector M49 terminals 7 and tilt sensor and telescopic sensor connector M28 terminals 2.

   7 (Y/R) - 2 (Y/R) : Continuity should exist. 

3. Check continuity harness between automatic drive positioner control unit connector M49 terminals 7 and ground.

   7 (Y/R) - Ground : Continuity should not exist. 

   Fig 3: Identifying Continuity Harness Between Automatic Drive Positioner Control Unit Connector M49 Terminals 7 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK : Replace tilt sensor and telescopic sensor.

NG : Repair or replace harness between automatic drive positioner control unit and tilt sensor and telescopic sensor.