Key Warning Chime Does Not Operate

Check if the key switch fuse [No. 19, located in the fuse block (J/B)] is blown. Refer to "WIRING DIAGRAM - CHIME -  ".

Is the fuse blown?

• YES: Replace the fuse. Be sure to repair the cause of malfunction before installing new fuse.
• NO: GO TO 2.

With key removed from the ignition key cylinder and the front door LH open, turn the lighting switch to 1st or 2nd position.

Does warning chime sound?

• YES: GO TO 3.
• NO: Go to "ALL WARNING CHIMES DO NOT OPERATE  " or "KEY WARNING CHIME AND LIGHT WARNING CHIME DO NOT OPERATE (SEAT BELT WARNING CHIME DOES OPERATE)  ".

With CONSULT-II 

With "DATA MONITOR" of "BUZZER", confirm "KEY ON SW" changes when the key is inserted/removed from the ignition key cylinder.

• When key is inserted in ignition key cylinder: KEY ON SW ON 
• When key is removed from ignition key cylinder: KEY ON SW OFF 
  Fig 1: CONSULT-II - KEY ON SW ON

  Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II 

Check voltage between BCM harness connector M18 terminal 37 (B/R) and ground.

Fig 2: BCM Harness Connector M18 Terminal 37 (B/R) And Ground Voltage Specification Chart

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Checking Voltage Between BCM Harness Connector M18 Terminal 37 (B/R) And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

• OK: Replace the BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".
• NG: GO TO 4.

1. Turn ignition switch OFF.
2. Disconnect key switch and key lock solenoid connector.
3. Check continuity between key switch and key lock solenoid connector M27 terminals 3 and 4.

Fig 4: Key Switch And Key Lock Solenoid Connector Terminals Continuity Specification Chart

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 5: Checking Continuity Between Key Switch And Key Lock Solenoid Connector M27 Terminals 3 And 4

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

• OK: GO TO 5.
• NG: Replace the key switch and key lock solenoid.

1. Disconnect BCM connector.
2. Check continuity between BCM harness connector M18 terminal 37 (B/R) and key switch and key lock solenoid harness connector M27 terminal 4 (B/R).
   • Continuity should exist. 
3. Check continuity between BCM harness connector M18 terminal 37 (B/R) and ground.
   • Continuity should not exist. 

OK or NG

• OK: GO TO 6.
• NG: Repair harness or connector.

Fig 6: Checking Continuity Between BCM Harness Connector M18 terminal 37, Key Switch And Key Lock Solenoid Harness Connector M27 Terminal 4

Courtesy of NISSAN MOTOR CO., U.S.A.

Check voltage between key switch and key lock solenoid harness connector M27 terminal 3 (Y/R) and ground.

• Battery voltage should exist. 

OK or NG

• OK: Replace the BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".
• NG: Check harness for open or short between fuse and key switch and key lock solenoid.

Fig 7: Checking Voltage Between Key Switch, Key Lock Solenoid Harness Connector M27 Terminal 3 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.