Consult-II Basic Operation Procedure

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

With the ignition switch OFF, connect "CONSULT-II" and "CONSULT-II CONVERTER" to the data link connector, and turn ignition switch ON.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START (NISSAN BASED VHCL)".

Fig 2: CONSULT-II BASIC OPERATION PROCEDURE - Identifying START (NISSAN BASED VHCL)
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM" on "SELECT SYSTEM" screen. If "BCM" is not indicated, go to "CONSULT-II INSPECTION PROCEDURE ".

Fig 3: CONSULT-II BASIC OPERATION PROCEDURE - Identifying SELECT SYSTEM
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BUZZER" or "BCM".

Fig 4: CONSULT-II BASIC OPERATION PROCEDURE - Identifying BUZZER
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "DATA MONITOR" or "SELF-DIAG RESULTS".

Fig 5: CONSULT-II BASIC OPERATION PROCEDURE - Identifying SELF-DIAG RESULTS
Courtesy of NISSAN MOTOR CO., U.S.A.