Multifunction Switch and Display Circuit Inspection

CHECK MULTIFUNCTION SWITCH AND DISPLAY OPEN CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect multifunction switch connector and display connector.
3. Check continuity between multifunction switch harness connector M83 terminal 9 (R) and display harness connector M82 terminal 16 (R).
  1. 9 (R) - 16 (R): Continuity should exist.
4. Check continuity between multifunction switch harness connector M83 terminal 10 (L) and display harness connector M82 terminal 15 (L).
  1. 10 (L) - 15 (L): Continuity should exist.
OK or NG
1. OK: Replace multifunction switch.
2. NG: Repair harness or connector.
Fig 1: Checking Multifunction Switch And Display Open Circuit Connector
Courtesy of NISSAN MOTOR CO., U.S.A.