LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2005 >> G35 Base, 2D Coupe, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control System - Coupe >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 3 and 4 under the following conditions.
    STOP LAMP SWITCH CONTINUITY

    Condition Continuity
    Brake pedal: Fully released. Should not exist.
    Brake pedal: Slightly depressed. Should exist.

    If NG, adjust stop lamp switch installation, refer to BRAKE PEDAL , and perform step  3 again.

    Fig 1: Checking Stop Lamp Switch Continuity
    G02334233Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals