Diagnostic Procedure

WITH CONSULT-II 

1. Start engine.
2. Select "SELECTION FROM MENU" in "DATA MONITOR" mode for "A/T" with CONSULT-II.
3. Drive vehicle in "D" position (3rd 4th gear), and confirm the ON/OFF actuation of "ATF PRES SW 3" and electrical current value of "I/C SOLENOID".
   Fig 1: Identifying Display - Data Monitor

   Courtesy of NISSAN MOTOR CO., U.S.A.
   Fig 2: Item Value Specification

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

1. OK: GO TO  4.
2. NG: GO TO 2.

Check TCM power supply and ground circuit. Refer to "MAIN POWER SUPPLY AND GROUND CIRCUIT ".

OK or NG

1. OK: GO TO 3.
2. NG: Repair or replace damaged parts.

Check the following.

• The A/T assembly harness connector pin terminals for damage or loose connection with harness connector.

OK or NG

1. OK: Replace the control valve with TCM. Refer to "CONTROL VALVE WITH TCM AND A/T FLUID TEMPERATURE SENSOR 2 ".
2. NG: Repair or replace damaged parts.

Perform DTC Confirmation Procedure.

• Refer to "DTC CONFIRMATION PROCEDURE ".

OK or NG

1. OK: INSPECTION END 
2. NG: GO TO  2.