Removal and Installation: Installation

Note the following, and install in the reverse order of removal.

• Do not allow engine mounting insulator to be damage and careful no engine oil gets on it.
• For a location with a positioning pin, insert it securely into hole of mating part.
• For a part with a specified installation orientation, refer to component figure in "REMOVAL AND INSTALLATION ".
• When installing engine mounting brackets (RH and LH) on cylinder block, tighten two upper bolts (shown as "A" in the figure) first. Then tighten two lower bolts (shown as "B" in the figure).
  Fig 1: Installing Two Upper And Lower Bolts

  Courtesy of NISSAN MOTOR CO., U.S.A.