Odo/Trip Meter and Illumination Control Switch Inspection

Symptom: Illumination control does not operate.

1. CHECK ODO/TRIP METER AND ILLUMINATION CONTROL SWITCH 
   1. Remove odo/trip meter and illumination control switch. Refer to "REMOVAL AND INSTALLATION OF ODO/TRIP METER AND ILLUMINATION CONTROL SWITCH ".
   2. Check continuity between odo/trip meter and illumination control switch harness connector terminals 25, 26, 35 or 36 and 27.
   Fig 1: Continuity Table

   Courtesy of NISSAN MOTOR CO., U.S.A.
   Fig 2: Checking Continuity Between Terminals 25, 26, 35 Or 36 And 27

   Courtesy of NISSAN MOTOR CO., U.S.A.

   OK or NG 

   1. OK: Replace combination meter.
   2. NG: Replace odo/trip meter and illumination control switch.