LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2004 >> QX56 AWD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Remove A/T undercover using power tools.
  2. Remove center exhaust tube and muffler. Refer to EXHAUST SYSTEM .
  3. Remove front and rear propeller shafts. Refer to REMOVAL (front), REMOVAL (rear).
    CAUTION: Be careful not to damage spline, sleeve yoke and rear oil seal when removing the rear propeller shaft
    NOTE: Insert a plug into rear oil seal after removing rear propeller shaft.
  4. Remove A/T mount bolts. Refer to TRANSMISSION ASSEMBLY .
  5. Position two suitable jacks under A/T and transfer assembly.
  6. Remove crossmember. Refer to REMOVAL AND INSTALLATION .
    WARNING: Support A/T and transfer assembly using two suitable jacks while removing crossmember.
  7. Disconnect the ATP switch, neutral 4LO switch, wait detection switch, transfer motor and transfer control device electrical connectors.
  8. Remove breather hoses from the actuator, transfer rear case and transfer motor.
  9. Remove the shift actuator from the extension housing.
  10. Remove transfer to A/T bolts.
    WARNING: Support transfer assembly with suitable jack while removing it.
  11. Remove transfer assembly.
scientia non olet · About LEMON Manuals