Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

When installing the transfer control unit, tighten bolts to the specified torque.
1. Transfer control unit bolts: 5.1 N.m (0.52 kg-m, 45 in-lb)
CAUTION:
- Do not connect harness connector to transfer control unit when 4WD shift switch is at 4LO.
After the installation, check perform self-diagnosis. Refer to "SELF-DIAGNOSTIC PROCEDURE ". If NG, adjust position between transfer assembly and transfer control unit. Refer to "PRECAUTIONS FOR TRANSFER ASSEMBLY AND TRANSFER CONTROL UNIT REPLACEMENT ".