Reverse Signal Check for Display Control Unit

1. Turn ignition switch ON.
2. Place selector lever into R-position. Do back-up lamps come on?

YES or NO

1. YES: GO TO 2.
2. NO: Check back-up lamp system. Refer to BACK-UP LAMP - QX56 .

With the selector lever in R-position, check voltage between display control unit and ground.

Fig 1: Displaying Terminal Connector Specifications

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Checking Voltage Between Display Control Unit And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

1. OK: Replace display control unit. Refer to REMOVAL AND INSTALLATION OF DISPLAY CONTROL UNIT  .
2. NG: Check harness for open or short between display control unit and back-up lamp position relay.