Combination Meter Circuit Check

WARNING: This page is about a different car, the 2002 Infiniti Q45. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn ignition switch OFF.
2. Check terminals and connector of combination meter for damage, bend and loose connection. (meter-side and harness-side)
OK or NG
1. OK >> GO TO 2.
2. NG >> Repair terminal or connector.
CHECK HARNESS FOR OPEN CIRCUIT
1. Disconnect combination meter connector.
2. Check resistance between combination meter harness connector M41 terminals 15 (LG/B) and 16 (P/B).
  15(LG/B)-16(P/B) : Approx. 54-66ohm
  
  Fig 1: Checking Resistance Between Combination Meter Harness Connector M41 Terminals 15 (LG/B) And 16 (P/B)
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK >> Replace combination meter.
2. NG >> Repair harness between splice points M13, M14 and combination meter.