Trouble Diagnosis: Consult-II: Notes

After performing "SELF-DIAGNOSTIC PROCEDURE (WITH CONSULT-II)" (Refer to " SELF-DIAGNOSTIC RESULT MODE " ), place check marks for results on the , " DIAGNOSTIC WORKSHEET " . References are provided following the items.

NOTICE:

The CONSULT-II electrically displays shift timing and lock-up timing (that is, operation timing of each solenoid).
Check for time difference between actual shift timing and the CONSULT-II display. If the difference is noticeable, mechanical parts (except solenoids, sensors, etc.) may be malfunctioning. Check mechanical parts using applicable diagnostic procedures.
Shift schedule (which implies gear position) displayed on CONSULT-II and that indicated in Service Manual may differ slightly. This occurs because of the following reasons:
- Actual shift schedule has more or less tolerance or allowance,
- Shift schedule indicated in Service Manual refers to the point where shifts start, and
- Gear position displayed on CONSULT-II indicates the point where shifts are completed.
Display of solenoid valves on CONSULT-II changes at the start of shifting, while gear position is displayed upon completion of shifting (which is computed by TCM).
Additional CONSULT-II information can be found in the Operation Manual supplied with the CONSULT-II unit.

DIAGNOSTIC TEST MODE AND FUNCTION

Diagnostic Test Mode

Function

Reference

Self-diagnostic Results

Self Diagnostic Results Can Be Read And Erased Quickly

⁽¹⁾

Data Monitor

Input/output Data In The ECM Can Be Read

⁽²⁾

CAN Diagnostic Support Monitor

The Results Of Transmit/receive Diagnosis Of CAN Communication Can Be Read

.....

Function Test

Conducted By CONSULT-II Instead Of A Technician To Determine Whether Each System Is "OK" Or "NG"

.....

DTC Work Support

Select The Operating Condition To Confirm Diagnosis Trouble Codes

⁽³⁾

ECM Part Number

ECM Part Number Can Be Read

.....

⁽¹⁾	Self-Diagnostic Result Mode

⁽²⁾	Data Monitor Mode

⁽³⁾	DTC Work Support Mode