DTC Confirmation Procedure
NOTE:
If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
With CONSULT-II:
- Turn ignition switch ON. (Do not start engine.)
- Select "DATA MONITOR" mode for "A/T" with CONSULT-II.
- Start engine.
- Drive vehicle and maintain the following conditions for at least 2 consecutive seconds.
Selector lever: "D" position
- If DTC is detected, go to " DIAGNOSTIC PROCEDURE " .
With GST
Follow the procedure "With CONSULT-II".