DTC Confirmation Procedure

WARNING: Always drive vehicle at a safe speed.

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II:

Turn ignition switch ON and select "DATA MONITOR" mode for "A/T" with CONSULT-II.
Start engine and maintain the following conditions for at least 10 consecutive seconds.
VHCL SPEED SE: 10 km/h (6 MPH) or more

ACCELE POSI: More than 1/8

Selector lever: "D" position
If DTC is detected, go to Diagnostic Procedure .