6. Check Intake Valve Timing Control Position Sensor Input Signal Circuit For Open And Short

1. Disconnect ECM harness connector.
2. Check harness continuity between the following;

   ECM terminal 73 (bank 1) and intake valve timing control position sensor terminal 2 or

   ECM terminal 74 (bank 2) and intake valve timing control position sensor terminal 2.

   Refer to WIRING DIAGRAM .

   Continuity should exist. 

3. Also check harness for short to ground and short to power.

OK or NG 

1. OK: GO TO 7.
2. NG: Repair open circuit or short to ground or short to power in harness or connectors.