Diagnostic Trouble Code (DTC) Confirmation Procedure

CAUTION:

Always drive vehicle at a safe speed.
If conducting this "DTC Confirmation Procedure" again, always turn ignition switch OFF and wait at least 10 seconds before continuing.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

Fig 1: Consult II Select System Display

Courtesy of NISSAN MOTOR CO., U.S.A.

WITH CONSULT-II

Turn ignition switch ON and select "DATA MONITOR" mode for "A/T" with CONSULT-II.
Start engine and accelerate vehicle from 0 to 25 km/h (0 to 16 MPH).

Fig 2: Consult II Select Diag Mode Display

Courtesy of NISSAN MOTOR CO., U.S.A.

WITHOUT CONSULT-II

Start engine.
Drive vehicle under the following conditions:
Selector lever in D and vehicle speed higher than 25 km/h (16 MPH).
Perform self-diagnosis.
Refer to "TCM SELF-DIAGNOSTIC PROCEDURE (NO TOOLS) ".

Fig 3: Checking Vehicle Speed Sensor Without Consult II

Courtesy of NISSAN MOTOR CO., U.S.A.