With Consult-II
- Check the coolant level in the reservoir tank and radiator.
Allow engine to cool before checking coolant level.
If the coolant level in the reservoir tank and/or radiator is below the proper range, skip the following steps and go to Diagnostic Procedure .
- Confirm whether customer filled the coolant or not. If customer filled the coolant, skip the following steps and go to Diagnostic Procedure .
- Start engine.
Be careful not to overheat engine.
- Make sure that cooling fan (crankshaft driven) operates normally.
If NG, Refer to COOLING FAN .
If OK, go to the following step.
- Stop engine and turn ignition switch ON.
- Select "COOLING FAN" in "ACTIVE TEST" mode with CONSULT-II.
- If the result are NG, go to Diagnostic Procedure .