Tilt Sensor Circuit Check

Check tilt sensor .

With CONSULT-II

With "TILT SEN" on the DATA MONITOR, operate the tilt switch to make sure voltage changes.

TILT SENSOR CIRCUIT CHECK

Monitor Item [OPERATION Or UNIT]	Parameter	Contents
TILT SEN	"V"	The tilt position (voltage) judged from the tilt sensor signal is displayed.

Fig 1: Identifying DATA MONITOR Display Screen

G02494729

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

Turn ignition switch OFF.
Check voltage between automatic drive positioner control unit connector and ground.

Fig 2: Displaying Tilt Terminals & Voltage Table
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Checking Voltage Between Automatic Drive Positioner Control Unit Connector & Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Tilt sensor circuit is OK.
NG: GO TO NEXT STEP.

Check harness .
1. Disconnect automatic drive positioner control unit connector and tilt sensor and telescopic sensor connector.
2. Check continuity harness between automatic drive positioner control unit connector M49 terminals 7 and tilt sensor and telescopic sensor connector M28 terminals 2.
  7 (Y/R) - 2 (Y/R): Continuity should exist.
  
  Fig 4: Checking Continuity Between Automatic Drive Positioner Control Unit Connector & Tilt Sensor & Telescopic Sensor Connector
  Courtesy of NISSAN MOTOR CO., U.S.A.
3. Automatic drive positioner control unit connector M49 terminals 7 and ground.
  7 (Y/R) - Ground: Continuity should not exist.
OK or NG
1. OK: Replace tilt sensor and telescopic sensor.
2. NG: Repair or replace harness between automatic drive positioner control unit and tilt sensor and telescopic sensor.