Diagnostic Procedure

With CONSULT-II 

1. Start engine.
2. Select "SELF-DIAG RESULTS" mode for "A/T" with CONSULT-II.
3. Drive vehicle.
   Fig 1: Self-Diagnosis With CONSULT-II (DTC P1730)

   Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II 

1. Drive vehicle.
2. Stop vehicle and turn ignition switch OFF.
3. Turn ignition switch "ON". (Do not start engine.)
4. Perform self-diagnosis. Refer to "TCM SELF-DIAGNOSTIC PROCEDURE (NO TOOLS) ".

OK or NG 

1. OK >> GO TO 2.
2. NG >>
   • Check each solenoid valves. Refer to "DTC P1772 LOW COAST BRAKE SOLENOID VALVE ", "DTC P1774 LOW COAST BRAKE SOLENOID VALVE FUNCTION ".

Perform "DTC Confirmation Procedure". Refer to "DTC CONFIRMATION PROCEDURE ".

OK or NG 

1. OK >> INSPECTION END 
2. NG >> GO TO 3.

1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.

OK or NG 

1. OK >> INSPECTION END 
2. NG >> Repair or replace damaged parts.