Diagnostic Procedure

With CONSULT-II 

1. Turn ignition switch to "ON" position. (Do not start engine.)
2. Select "SELECTION FROM MENU" in "DATA MONITOR" mode for "A/T" with CONSULT-II and check monitor "STARTER RELAY" (PNP relay) ON/OFF.

OK or NG 

OK >> GO TO  4.

NG >> GO TO  3.

Fig 1: Consult II Data Monitor Display

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II 

1. Turn ignition switch to "ON" position. (Do not start engine.)
2. Check the voltage between the TCM connector and ground.

Fig 2: Checking PNP Relay (Without Consult-II) (1 Of 2)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Checking PNP Relay (Without Consult-II) (2 Of 2)

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK >> GO TO  2.

NG >> GO TO 3.

Check the following items:

• PNP relay. Refer to "STANDARDIZED RELAY".
• Disconnections or short-circuits in the harness between TCM and the PNP relay
• Ground circuit for the PNP relay

OK or NG 

OK >> GO TO 4.

NG >> Repair or replace damaged parts.

Perform "DTC Confirmation Procedure". Refer to "DTC CONFIRMATION PROCEDURE ".

OK or NG 

OK >> INSPECTION END 

NG >> GO TO 5.

1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.

OK or NG 

OK >> INSPECTION END 

NG >> Repair or replace damaged parts.