Removal and Installation: Installation

Pay attention to the following when installing sensor. Tighten installation bolts and nuts to specified torques.

• When installing, make sure that there is no foreign material such as iron chips on pick-up and mounting hole of the sensor. Make sure that no foreign material has been caught in the sensor rotor motor. Remove any foreign material and clean the mount.
• When installing front sensor, be sure to press rubber grommets in until they lock at the three locations shown in diagram (2 at shock absorbers and 1 at body panel). When installed, harness must not be twisted. Green line on harness (shaded part) must be visible from front.