Line Pressure Test Procedure
- Check A/T fluid and engine oil levels. If necessary, add fluid and oil.
- Drive vehicle for approx. 10 minutes or until fluid and oil reach operating temperature.
ATF operating temperature:
50 - 80°C (122 - 176°F)
- Install pressure gauge to corresponding line pressure port.
- Set parking brake and block wheels.
- Continue to depress brake pedal fully while line pressure test is being performed at stall speed.
- Start engine and measure line pressure at idle and stall speed.
- When measuring line pressure at stall speed, follow the stall test procedure.
Line pressure: Refer to SDS, LINE PRESSURE .
- When measuring line pressure at stall speed, follow the stall test procedure.