Reverse Clutch: Assembly

Install D-ring and oil seal on piston.

Fig 1: Installing D-Ring & Oil Seal On Piston
Courtesy of NISSAN MOTOR CO., U.S.A.
- Take care with the direction of oil seal.
- Apply ATF to both parts.
Install piston assembly by turning it slowly.

Fig 2: Installing Piston Assembly By Turning It Slowly
Courtesy of NISSAN MOTOR CO., U.S.A.
- Apply ATF to inner surface of drum.
Install return springs and spring retainer on piston.
Set Tool on spring retainer and install snap ring while compressing return springs.

Fig 3: Installing Snap Ring While Compressing Return Springs
Courtesy of NISSAN MOTOR CO., U.S.A.
- Set Tool directly over return springs.
Install drive plates, driven plates, retaining plate and dish plates.
- Take care with order of plates.
Install snap ring.

Fig 4: Installing Snap Ring
Courtesy of NISSAN MOTOR CO., U.S.A.
Measure clearance between retaining plate and snap ring. If not within allowable limit, select proper retaining plate.

Fig 5: Measuring Clearance Between Retaining Plate & Snap Ring
Courtesy of NISSAN MOTOR CO., U.S.A.
1. Specified clearance:
  1. Standard 0.5 - 0.8 mm (0.020 - 0.031 in)
  2. Allowable limit 1.2 mm (0.047 in)
2. Retaining plate:
  1. Refer to SDS RETURN SPRING .
Check operation of reverse clutch.

Fig 6: Applying Compressed Air To Oil Hole In Assembly
Courtesy of NISSAN MOTOR CO., U.S.A.

Refer to DISASSEMBLY in REVERSE CLUTCH .