CONSULT-II Inspection Procedure: Notes

Turn ignition switch "OFF".
Connect "CONSULT-II" and CONSULT-II CONVERTER to the data link connector.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch "ON".
Touch "START (NISSAN BASED VHCL)".

Fig 2: START (NISSAN BASED VHCL) Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM".
If "BCM" is not indicated, go to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .

Fig 3: BCM Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "RETAINED PWR".

Fig 4: Retained PWR Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Select diagnosis mode.
"DATE MONITOR", "ACTIVE TEST" and "WORK SUPPORT" are available.

Fig 5: Select Diagnosis Mode Display
Courtesy of NISSAN MOTOR CO., U.S.A.