Mirror Motor (Driver Side) Circuit Check

CHECK DOOR MIRROR FUNCTION
Check the following.

Operation malfunction caused by a foreign object caught in door mirror face edge.

OK or NG
1. OK: GO TO 2.
2. NG: Repair the malfunctioning parts, and check the symptom again.

CHECK MIRROR MOTOR

With CONSULT-II

Check the operation with "MIRROR MOTOR LH" in the ACTIVE TEST.

TEST ITEM DESCRIPTION

Test item	Description
MIRROR MOTOR LH	The (driver side) mirror motor moves the mirror UP/DOWN and LEFT/RIGHT by receiving the drive signal.

Fig 1: CONSULT-II Display - MIRROR MOTOR LH In ACTIVE TEST

G03107595

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

GO TO 3.

OK or NG

OK: Mirror motor (driver side) circuit is OK.
NG: GO TO 3.

CHECK DOOR MIRROR MOTOR (DRIVER SIDE) HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit connector and door mirror (driver side) connector.
3. Check continuity between automatic drive positioner control unit connector M49 terminal 16 (P), 31 (R/W), 32 (G/B) and door mirror (driver side) connector D2 terminal 8 (P), 9 (PU), 10 (GY).
  16 (P) - 8 (P): Continuity should exist.
  
  31 (R/W) - 10 (GY): Continuity should exist.
  
  32 (G/B) - 9 (PU): Continuity should exist.
  
  Fig 2: Checking Door Mirror Motor (Driver Side) Harness Continuity
  Courtesy of NISSAN MOTOR CO., U.S.A.
4. Check continuity between automatic drive positioner control unit connector M49 terminal 16 (P), 31 (R/W), 32 (G/B) and ground.
  16 (P) - Ground: Continuity should not exist.
  
  31 (R/W) - Ground: Continuity should not exist.
  
  32 (G/B) - Ground: Continuity should not exist.
OK or NG
1. OK: GO TO 4.
2. NG: Repair or replace harness between automatic drive positioner control unit and door mirror (driver side).

CHECK MIRROR MOTOR SIGNAL

Connect automatic drive positioner control unit and door mirror (driver side) connector.
Turn ignition switch to ACC position.
Check voltage between door mirror (driver side) connector and ground.

Fig 3: Checking Mirror Motor Signal
Courtesy of NISSAN MOTOR CO., U.S.A.

TERMINAL VOLTAGE

Connector	Terminals (Wire color)		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D2	8(P)	Ground	When motor is DOWN or RIGHT operation	Battery voltage
	8(P)		Door mirror remote control switch is neutral	0
	9 (PU)		When motor is LEFT operation	Battery voltage
	9 (PU)		Door mirror remote control switch is neutral	0
	10 (GY)		When motor is UP operation	Battery voltage
	10 (GY)		Door mirror remote control switch is neutral	0

OK or NG

OK: Replace door mirror motor (driver side).
NG: Check the condition of the harness and the connector.