Removal And Installation - AWD Model: Installation

WARNING: This page is about a different car, the 2004 Infiniti FX35 and 2003 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Note the following, and install in the reverse order of removal.

For a location with a positioning pin, insert it securely into hole of mating part.
For a part with a specified installation orientation, refer to Figure.
When installing engine mounting bracket on cylinder block, tighten two upper bolts (shown as A in figure) first Then tighten two lower bolts (shown as B in Fig 1 and Fig 2 ). (LH and RH sides)

Fig 1: Identifying Engine Mounting Bracket Bolts (Left Side)
Courtesy of NISSAN MOTOR CO., U.S.A.
Install engine mounting bracket (lower) paying attention to the following.
- a. Temporarily tighten mounting bolts (shown as C, D and E in Fig 2).
  
  Fig 2: Identifying Engine Mounting Bracket Bolts (Right Side)
  Courtesy of NISSAN MOTOR CO., U.S.A.
- b. Tighten mounting bolts to the specified torque with following mounting surfaces touched.
Engine mounting bracket to engine mounting bracket (lower) (shown as C and D in figure).
Front final drive to engine mounting bracket (lower) (shown as E in figure).