Removal And Installation - 2WD Model: Installation

WARNING: This page is about a different car, the 2004 Infiniti FX35 and 2003 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Note to the following, and install in the reverse order of removal.

For a location with a positioning pin, insert it securely into hole of mating part.
For a part with a specified installation orientation, refer to Figure.
When installing engine mounting bracket on cylinder block, tighten two upper bolts (shown as A in figure) first. Then tighten two lower bolts (shown as B in figure). (LH and RH sides)

Fig 1: Identifying Engine Mounting Bracket Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
Tighten rear member mounting bolts in numerical order shown in figure.

Fig 2: Tightening Rear Member Mounting Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.