DTC Confirmation Test (With CONSULT-II)
NOTE:
If an incorrect fuel filler cap is used or fuel filler cap is not tightened properly, MIL may illuminate. Use only a genuine NISSAN rubber hose as replacement. Never remove fuel filler cap during DTC confirmation test procedure.
- Ensure EVAP hoses are properly connected to EVAP canister purge volume control solenoid valve.
- Ensure fuel level is between 1/4 and 3/4 full and vehicle is parked on a flat, level surface.
- Open engine hood.
- Tighten fuel filler cap securely until ratcheting sound is heard.
- Turn ignition switch on. Turn ignition switch off and wait at least 10 seconds.
- Turn ignition switch on. Select DATA MONITOR mode.
- Ensure COOLAN TEMP/S is 32-158°F (0-70°C) and INT/A TEMP SE is 32-140°F (0-60°C).
- Select EVAP SML LEAK P0442/P1442 of EVAPORATIVE SYSTEM in DTC WORK SUPPORT mode. Follow instructions displayed. If engine speed cannot be maintained within range displayed, go to TROUBLESHOOTING - NO CODES article.
- Ensure that OK is displayed. If NG is displayed, select SELF-DIAG RESULTS and ensure that EVAP GROSS LEAK (P0455) is displayed. If correct item is displayed, go to DIAGNOSTIC PROCEDURE . If P0442 is displayed, go to DIAGNOSTIC PROCEDURE under DTC P0442.