Check Stop Lamp Switch

1. Disconnect stop lamp switch connector.
2. Check voltage between stop lamp switch connector E210 terminal 1 (GY) and ground.

   1 (GY) and ground: Battery voltage 

OK or NG

1. OK: GO TO 2.
2. NG: Repair or replace harness between stop lamp switch and fuse.
   Fig 1: Inspecting Stop Lamp Switch Power Supply Circuit

   Courtesy of NISSAN MOTOR CO., U.S.A.

Check continuity between stop lamp switch connector E210 terminal 1 and 2.

1-2 

Brake pedal depressed: Continuity should exist. 

Brake pedal not depressed: Continuity should not exist. 

OK or NG

1. OK: GO TO 3.
2. NG: Replace stop lamp switch.
   Fig 2: Inspecting Stop Lamp Switch Operation

   Courtesy of NISSAN MOTOR CO., U.S.A.

1. Check continuity between stop lamp switch connector E210 terminal 2 (P) and intelligent Key unit connector M34 terminal 26 (P/L).

   2 (P)-26(P\L):Continuity should exist. 

2. Check continuity between stop lamp switch connector E210 terminal 2 (P) and ground.

   2(P)- Ground: Continuity should not exist. 

OK or NG

1. OK: Stop lamp switch is OK.
2. NG: Repair or replace harness.