LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2003 >> FX35 RWD >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brake Control System >> On-Vehicle Service >> Adjustment Of Steering Angle Sensor Neutral Position

Adjustment Of Steering Angle Sensor Neutral Position

In case of doing work that applies to the list below, make sure to adjust neutral position of steering angle sensor before running vehicle.

ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

Situation ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Removing/Installing ABS actuator and electric unit (control unit) (2)
Replacing ABS actuator and electric unit (control unit) (1)
Removing/Installing steering angle sensor (1)
Removing/Installing steering components (1)
Removing/Installing suspension components (1)
Removing/Installing the same tire to the same position (2)
Change 4 tires to new ones (2)
Change some of 4 tires to new ones (not 4 tires) (2)
Tire rotation (2)
Adjusting wheel alignment (1)
(1) Required
(2) Not required
CAUTION: To adjust neutral position of steering angle sensor, make sure to use CONSULT-II. (Adjustment cannot be done without CONSULT-II.)
  1. Stop vehicle with front wheels in straight-ahead position.
  2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector on vehicle, and turn ignition switch ON (do not start engine).
    CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
  3. Touch "ABS", "WORK SUPPORT" and "ST ANGLE SENSOR ADJUSTMENT" on CONSULT-II screen in this order. Refer to CONSULT-II BASIC OPERATION PROCEDURE .
  4. Touch "START".
    CAUTION: Do not touch steering wheel while adjusting steering angle sensor.
  5. After approximately 10 seconds, touch "END". (After approximately 60 seconds, it ends automatically.)
  6. Turn ignition switch OFF, then turn it ON again.
    CAUTION: Be sure to carry out above operation.
  7. Run vehicle with front wheels in straight-ahead position, then stop.
    Fig 1: CONSULT-II Display Str Angle Sensor Adjustment
    G03106733Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Select "DATA MONITOR", "SELECTION FROM MENU", and "STR ANGLE SIG" on CONSULT-II screen. Then make sure "STR ANGLE SIG" is within 0 +/-3.5 deg. If value is more than specification, repeat steps 3 to 7.
  9. Erase memory of ABS actuator and electric unit (control unit) and ECM.
  10. Turn ignition switch OFF.
scientia non olet · About LEMON Manuals