Removal And Installation

WARNING: This page is about a different car, the 2004 Infiniti Q45. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Displaying VDC/TCS/ABS Actuator & Components

Courtesy of NISSAN MOTOR CO., U.S.A.

Pay attention to the following when removing actuator.

CAUTION:

Before servicing, disconnect battery cables.
To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being damaged. To install, use flare nut wrench (commercial service tool).
Do not remove and install actuator by holding harness.
After work is completed, bleed air from brake piping. Refer to BLEEDING PROCEDURE .
Be sure to securely connect the ground cable.