LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2002 >> Q45 >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Diagnosis) >> DTC P1702: Transmission Control Module (Ram) >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2004 Infiniti Q45. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-II 

  1. Turn ignition switch to "ON" position. (Do not start engine.)
  2. Select "DATA MONITOR" mode for A/T with CONSULT-II.
  3. Start engine.
  4. Run engine for at least 2 consecutive seconds at idle speed.
  5. If DTC is detected, go to DIAGNOSTIC PROCEDURE .
scientia non olet · About LEMON Manuals