DTC Confirmation Test (Using CONSULT-II)
NOTE:
The following test may be performed with drive wheels lifted or by road testing vehicle.
- Start engine. Read VHCL SPEED SE in DATA MONITOR mode with CONSULT-II. If VHCL SPEED SE exceeds 6 MPH when rotating wheels at more than 6 MPH, go to next step. If VHCL SPEED SE does not exceed 6 MPH when rotating wheels at more than 6 MPH, go to DIAGNOSTIC PROCEDURE .
- Select DATA MONITOR mode with CONSULT-II. Warm engine to normal operating temperature. Maintain the following conditions for at least 10 consecutive seconds:
- ENG SPEED: 1650-3000 RPM (A/T); 1900-3900 RPM (M/T).
- COOLAN TEMP/S: more than 158°F (70°C).
- B/FUEL SCHDL: 4.8-12.0 msec (A/T); 4.5-10.5 msec (M/T).
- PW/ST SIGNAL: OFF.
If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.